Just make sure surface is REALLY clean with peiĭont think that should need glue but then I dont use abs I'm a noob - i started with some ambitious prints, failed 2 of 3, and now I'm calibrating and doing things from the ground upĪnd got a decent polish with a cold acetone vapor bath It warps upward just a tiny bit - I'm using ABSĪs to actual settings, I'm still getting beyond the default cura profiles The elmers glue does the trick - only thing i see that i have questions on are slight little "flaps" on the ends of lines It still has couple of em but it works fine My pei covering is kinda janky, too - i got a "used once" printer, and it has a couple defects Things didnt line up perfectly but ill get itġ5 hours seems like a long time to print?įirst layer speed might work well at 35mm/s This is a hard one to print because it covers the hole surface of the bed Im gonna be printing an up-board case when i can get this thing working ƬTION needs elmer's purple clue, possibly Hm if I recall pei is fine as long as its clean No I meant what is bed surface? glass? tape? alum?Īnd a small coating of elmers purple clue Then slid the card along X and Y axes on near, middle, and far sides of the bed Then calibrated the Z axis by getting consistent, very slight pressure on a business card at all 4 corners I used calipers and leveled the bed to the X axis rails Well crunch I guess you love me, bought 3 1KG I think my Y jerk setting is too high, can anyone confirm my hypothesisĨ mm with linear bearings, just checking my firmware files Hey, my 3d printer occasionally seems to be missing steps in the Y axis, it is a mendelmax 1.5 with the moving Y carraige. I have used it for hundreds of hours so far. turned it to kindle pw2 screensaver picture Jeffdm_h_: yeah I took pic of my transparent petg one, beaytful.
3DLABPRINT ROSTOCK CODE
The variation is beautiful from the inside: otherwise not desirableĪtomic has been dead-on consistency in my experience.Ītomic seems like the most recommended and that coupon code really helped tip the scales This is Push translucent green PLA: REPRAP100 REPRAP12 coupon for 12% off orders of 2 or more 1KG rolls, reprap30 for 30% off 10 or more 1 kg rolls, no 3.5kg rolls or clearance items allowed for coupon use, please respect that, orders with 3.5kg or clearance items will be cancelled. Push I've done OK build-wise but their mixing was terrible.Ītomic is atomic filament ( good stuff ) and is made by crunch. I think I may have narrowed it down to Atomic Filament or Push Plastics, any recommendations? I'm trying to decide where to buy PLA, Hatchbox doesn't seem to be available in a lot of colors, and some reports of quality. I don't know if it was because my current was near the bottom end of its range or not. My experience with the 860 wasn't that great. Just use a more accurate servo for the nozzle control It needs to lift, stop extrude, then wipe noozle around Haha yes he strugges with layers in the first part I really want to build the Bold Machines Fantasy Castle. Though hasn't been done that huge that I've seen. I'll be happy to build a 600mm Benchy if I get a filament sponsorship.īut I don't really want to build a Benchy, it's been overdone. Someone broke crunch, quick someone cook up awesome steak for him! Slicer have hard time doing small details
0 kommentar(er)
